Roll over image to zoom in
Hantek2D82AUTO
An all-new handheld oscilloscope-Hantek2000 series, it continues the compact and lightweight concept but with a new generation of 4 in 1 multifunction tester: Automotive Diagnostic, oscilloscope, signal source and multimeter; A small volume of the non-profit grip by a single hand; The suspendingstand was designed to support multi-angle adjustment; Ultra-low-power, Type C charging interface, each 2 hours battery charge allow working one full day or standbytwo months; High-definition color LCD screen display clear and delicate; Minimalist keyboard design simplifyoperation, easy to use.
| Model | Hantek2D82AUTO | |||
| Vehicle Testing Mode | ||||
| Vehicle Diagnosis | Vehicle Diagnostic Function | Ignition | Primary Ignition (Voltage) | |
| Primary Ignition（current） | ||||
| Primary Ignition（Voltage& Current） | ||||
| Primary Ignition (Crankshaft Senser) | ||||
| Primary Ignition&SecondaryIgnition | ||||
| Secondary | Secondary Ignition Distributor Type (Plug Lead) | |||
| Secondary Ignition Distributor Type (King Lead) | ||||
| Secondary DIS (Positive-fired) | ||||
| Secondary DIS or CPC (Negative-fired)） | ||||
| Secondary Coil Output Diagnosis | ||||
| Secondary Ignition&Primary Ignition | ||||
| Sensors | Air Flow Meter | Air Flow Meter (Hot Wire) | ||
| Air Flow Meter (Air Vane) | ||||
| Air FlowSensor (BOSCH Diesel) | ||||
| Air Intake PressureSensor (BOSCH Diesel) | ||||
| Camshaft | Camshaft (Inductive) | |||
| Camshaft (AC Excited) | ||||
| Camshaft (Hall Effect) | ||||
| Camshaft (BOSCH Common Rail Diesel) | ||||
| Crankshaft | Crankshaft Inductive Running | |||
| Crankshaft Inductive Cranking | ||||
| Crankshaft Hall Effect | ||||
| Crankshaft Sensor &Primary Ignition | ||||
| Distributor | Distributor Pick-up (Hall Effect) | |||
| Distributor Inductive Pick-up Cranking | ||||
| Distributor Inductive Pick-up Running | ||||
| Lambda Sensors | Lambda Sensor Titania | |||
| Lambda Sensor Zirconia | ||||
| Lambda Sensor Zirconia Pre & Post cat | ||||
| Throttle Position | Throttle Position Potentiometer | |||
| Throttle Position Switch | ||||
| Throttle Pedal Switch (Bosch Diesel) | ||||
| ABS Digital Speed Sensor | ||||
| ABS Analog Speed Sensor | ||||
| Coolant Temperature (5V) | ||||
| Coolant Temperature (GM/Vauxhall Simtec | ||||
| Crash Sensor | ||||
| MAP Analog | ||||
| MAP Digital | ||||
| Hall Effect Road Speed Sensor | ||||
| Accelerator Pedal (Bosch Diesel) | ||||
| Bus Diagnosis | CAN Bus | CAN Bus Data View | ||
| CAN Bus Signal Integrity | ||||
| CAN Bus LH Long Capture | ||||
| LIN Bus | LIN Bus | |||
| Engine | Petrol | Single-point Injector (Voltage) | ||
| Single-point Injector (Current) | ||||
| Multi-point Injector (Voltage) | ||||
| Multi-point Injector (Current) | ||||
| Injector Voltage & Current | ||||
| Injector Current & Primary Ignition | ||||
| Diesel | Common Rail Diesel (Current) | |||
| Injector Bosch CDi 3 (Current) | ||||
| Injector Bosch Diesel (Idling) | ||||
| Injector Bosch Diesel (Accelerating) | ||||
| Diesel Glow Plugs | ||||
| Electronic Fuel Pump | ||||
| Carbon Canister Solenoid Valve | ||||
| ERG Recirculation Solenoid Valve | ||||
| Stepper Motor Example 1 | ||||
| Stepper Motor Example 2 | ||||
| Idle Speed Control Valve (Rotary) | ||||
| Idle Speed Control Valve (Electromagmetic) | ||||
| Throttle Servomotor (Idling) | ||||
| Throttle Servomotor (Accelerating) | ||||
| Bosch CDi3 Quantity Control Valve | ||||
| Bosch CDi3 Pressure Regulator Valve | ||||
| Variable-Speed Cooling Fan On | ||||
| Variable-Speed Cooling Fan Off | ||||
| Variable Camshaft Valve Timing | ||||
| Startup & Charge | Charging Circuits | Charging Circuits Current/Voltage | ||
| Charging Circuits Current/Voltage Starting 24V | ||||
| Charging Circuits Current/Voltage Idling 24V | ||||
| Charging Circuits Alternator AC Ripple/Diode Diagnosis | ||||
| Relative Compression Petrol | ||||
| Relative Compression Diesel | ||||
| Starting Voltage Drop | ||||
| Oscilloscope Mode | ||||
| Bandwidth | 80MHz | |||
| Channel | 2CH+DMM+AWG | |||
| Horizontal | ||||
| Sample Rate Range | 250MSa/s(Single-channel), 125MSa/s(Dual-channel) | |||
| Waveform Interpolation | (sin x)/x | |||
| Record Length | 3K samples per dual-channel | |||
| SEC/DIV Range | 5ns/div~500s/div 1, 2, 5 sequence | |||
| Vertical | ||||
| A/D Converter | 8-bit resolution,each channel sampled simultaneously | |||
| VOLTS/DIV Range | 10mV/div~10V/divat input BNC | |||
| Bandwidth Limit, typical | 20MHz | |||
| Low Frequency Response (-3db) | ≤10Hz at BNC | |||
| Rise Time at BNC, typical | ≤5ns | |||
| DC Gain Accuracy | ±3% for Normal or Average acquisition mode, 10V/div to 10mV/div | |||
| Note: Bandwidth reduced to 6MHz when using a 1X probe. | ||||
| Acquisition | ||||
| Acquisition Modes | Normal | |||
| Trigger | ||||
| Type | Edge | |||
| Mode | Auto, Normal, single | |||
| Level | ±4 divisions from center of screen | |||
| Trigger Level Accuracy | 0.2div × volts/div within ±4 divisions from center of screen | |||
| Slope | Rising, Falling, Rising & Falling | |||
| Source | CH1/CH2 | |||
| Input | ||||
| Coupling | DC, AC or GND | |||
| Input Impedance, | 25pF±3 pF, 1MΩ±2% | |||
| DC coupled | ||||
| Probe Attenuation | 1X, 10X | |||
| Supported Probe Attenuation Factors | 1X, 10X, 100X, 1000X | |||
| Maximum Input Voltage | 150VRMS | |||
| Measurement | ||||
| Cursor | Voltage difference between cursors: △V | |||
| Time difference between cursors: △T | ||||
| Automatic Measurements | Frequency, Amplitude | |||
| Arbitrary Waveform Generator Mode | ||||
| Waveform Frequency | Sine: 1Hz~25MHz | |||
| Square: 1Hz~10MHz | ||||
| Ramp: 1Hz~1MHz | ||||
| EXP: 1Hz~5MHz | ||||
| Sampling | 250MSa/s | |||
| Amplitude | 2.5Vpp(50Ω) | |||
| 5Vpp(High impedance) | ||||
| Frequency Resolution | 0.001 | |||
| Channel | 1CH waveform output | |||
| Waveform Depth | 512Sa | |||
| Vertical Resolution | 12 bit | |||
| Frequency Stability | <30ppm | |||
| Output Impedance | 50 Ω | |||
| DMM Testing Modes | ||||
| Maximum Resolution | 4000 Counts | |||
| DMM Testing Modes | Voltage,Current,Resistance,Capacitance,Diode &On-Off | |||
| Maximum Input Voltage | AC:600V, DC: 800V | |||
| Maximum Input Current | AC: 10A, DC:10A | |||
| Input Impedance | 10MΩ | |||
| Measurement Term | Range | Accuracy | Resolution | |
| DC Voltage | 400.00mV | ± (0.8% + 5) | 100uV | |
| 4.000V | 1mV | |||
| 40.00V | 10mV | |||
| 400.0V | 100mV | |||
| 600.0V | ± (1% + 2) | 1V | ||
| Overload protection: 400mV: 250V, other: 600Vrms. | ||||
| AC Voltage | 4.000V | ± (1.2% + 5) | 1mV | |
| 40.00V | 10mV | |||
| 400.0V | 100mV | |||
| 600.0V | ±(1.5% + 5) | 1V | ||
| Frequency: 40Hz~400Hz; | ||||
| Frequency of 400V and 600V: 40Hz~100Hz | ||||
| DC Current | 40.00mA | ± (1% + 2) | 10uA | |
| 200.0mA | ± (1.5% + 2) | 100uA | ||
| 4.000A | ± (1.8% + 2) | 1mA | ||
| 10.00A | ± (3% + 2) | 10mA | ||
| Overload protection: | ||||
| self restoring fuse: 200mA/250V, 4A and 10A range no fuse. | ||||
| AC Current | 40.00mA | ± (1.3% + 2) | 10uA | |
| 400.0mA | ± (1.8% + 2) | 100uA | ||
| 4.000A | ± (2% + 3) | 1mA | ||
| 10.00A | ± (3% + 5) | 10mA | ||
| Frequency: 40Hz~400Hz; | ||||
| self restoring fuse: 200mA/250V, 4A and 10A range no fuse. | ||||
| Resistance | 400.0Ω | ±(1% + 3) | 0.1Ω | |
| 4.000KΩ | ±(1.2% + 5) | 1Ω | ||
| 60.00KΩ | 10Ω | |||
| 400.0KΩ | 100Ω | |||
| 4.000MΩ | 1KΩ | |||
| 40.00MΩ | ± (1.5%±3) | 10KΩ | ||
| Overload protection: 220Vrms | ||||
| Capacitance | 40.00nF | ±(3% + 5) | 10pF | |
| 400.0nF | 100pF | |||
| 4.000uF | 1nF | |||
| 40.00uF | 10nF | |||
| 100.0uF | 100nF | |||
| Overload protection: 220Vrms | ||||
| Diode | 0V~2.0V | |||
| On-Off | <50Ω | |||
| General Specifications | ||||
| Display | ||||
| Display Type | 2.8 inch64K color TFT | |||
| Display Resolution | 320 horizontal by 240 vertical pixels | |||
| Display Contrast | Adjustable | |||
| Power Supply | ||||
| Supply Voltage | 100V-240VAC, 50Hz-60Hz; DC INPUT: 5VDC, 2A | |||
| Power Consumption | <2.5W | |||
| Fuse | T, 3A | |||
| Battery | 2600mA*2 | |||
| Environmental | ||||
| Operating Temperature | 0~50 °C (32~122 °F) | |||
| Storage Temperature | -40~+71 °C (-40~159.8 °F) | |||
| Humidity | ≤+104℉(≤+40°C): ≤90% relative humidity | |||
| 106℉~122℉ (+41°C ~50°C): ≤60% relative humidity | ||||
| Cooling Method | Convection | |||
| Altitude | Operating and | 3,000m (10,000 feet) | ||
| Nonoperating | ||||
| Mechanical Shock | Random Vibration | 0.31gRMS from 50Hz to 500Hz, 10 minutes on each axis | ||
| Nonoperating | 2.46gRMS from 5Hz to 500Hz, 10 minutes on each axis | |||
| Operating | 50g, 11ms, half sine | |||
| Mechanical | ||||
| Dimension | 199 x 98x 40mm (L x W x H) | |||
| Weight | 400g | |||
Reviews
There are no reviews yet.