Back to Top



Current clamps CC 60A

Current clamps CC 60A are designed for alternating current and direct current measuring in frequency range from 40Hz to 20kHz. Thanks to divided magnetic circuit (clamp jaws) it is possible to clasp the measuring wire with no need of disconnecting or insulation infringement. The measured wire maximal diameter which the current clamps are able to clasp, is 9mm (hole 10mm). Measured voltage range is 10mA to 60A. The probe tip is of the BNC connector, enabling lossless connection to the oscilloscope. 


Use in diagnosis

Tests of the injection nozzles
Current clamps are mostly used in diagnosis of the injection nozzles of compression-ignition engines. The current probe enables measuring the amount of current which is needed for opening the injection nozzle. Depending on the injection system (PD, CR etc.) the current consumtion varies from 13A to 18A (approximate values). The clamps can be used for current measuring of all types of injection nozzles, which are opened by control unit.
In the control program Hantek 3064A there are preset measurements for tests of the injection nozzles on system Commonrail and Bosch.

Current consumption of the fuel pump

Standard current consumption of the fuel pump can vary from 1,5 to 2A, depending on the type of the pump. The current consumption can significantly rise if the line between relay and pump oxidize.


Warranty 2 years
Model No
Parameters It is possible to use Current clamps CC 60A as accessories for all types of oscilloscopes.


Videos No


Manual No
Datasheet No
Software No
Firmware No


You're reviewing: CURRENT CLAMP Tecpel 60A

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

New handhelds